No products were found matching your selection.
Other Related Products
-
- Material: PE/LDPE temporary surface film
- Adhesive: Removable water-based acrylic adhesive
- Thickness: 40-120um typical
- Width: 100-2000mm, slit to order
- Colors: Transparent, blue, white, black-white
- Surfaces: Ceramic, porcelain, glazed, polished tiles
-
- Material: Biaxially oriented polyethylene
- Appearance: Clear or high-gloss
- Typical thickness: 18-40 um, grade dependent
- Width: Master rolls and custom slit rolls
- Surface treatment: One-side or two-side corona treatment
- Grade options: Printing, laminating, sealable or non-sealable
-
Chemical resistance PET film data is meaningful only when construction, reagent, concentration, contact method, temperature, and exposure time are defined. It applies to PET/BOPET base film, coated PET, and adhesive-backed protective film. Compare appearance, haze, mechanical retention, coating integrity, and peel behavior after exposure. Actual-substrate testing should confirm sensitive coatings, repeated cleaning, or delayed removal.
-
- Material: optically clear acrylic OCA adhesive
- Structure: no-substrate adhesive with PET release liners
- Thickness: 25um-250um, grade-dependent
- Appearance: transparent, low haze, clean surface
- Format: roll, sheet, kiss-cut or die-cut part
- Use: glass, touch layer, and display module bonding
-
- Base film: clear PET liner
- Thickness: 12-100 um
- Width: slit or jumbo roll
- Color: transparent or light translucent
- Coating: silicone release layer
- Use: tapes, labels, die-cut parts
-
- Material: High-density polyethylene (HDPE)
- Forms: Film rolls, sheet rolls and cut sheets
- Density: Grade-dependent, typically 0.94-0.97 g/cm3
- Colors: Natural, milky white, black or custom color
- Processing: Slitting, sheet cutting and optional perforation
- Uses: Liners, separators and temporary barriers
-
A clear film to protect graphics should keep printed and display-facing surfaces visible while reducing scratches, dust, fingerprints, and handling marks during converting, assembly, storage, transport, or installation. Key risks are trapped particles, edge lift, adhesive transfer, ink lift, bubbles, haze, and appearance change after removal. Selection depends on contact surface, holding force, dwell, exposure, visibility, and removal stage. Because inks, coatings, acrylics, overlays, and display surfaces behave differently, representative sample testing is recommended when the surface, process, or protection time changes.
-
This ASTM E1745 technical data explains how a polyethylene film vapor retarder should be reviewed below concrete slabs. It separates standard limits from typical references, lot-specific results, and project-confirmed values for thickness, water vapor permeance, tensile strength, puncture resistance, conditioned performance, and traceability. Final acceptance should use the submitted grade, current reports, and a representative mock-up under intended project conditions.
-
- Material: Biaxially oriented PET polyester film
- Color: Milky white, hazy white, or natural clear by grade
- Thickness: 50 um – 350 um
- Width: Slit roll or master roll, custom width available
- Surface: Untreated, corona treated, or chemically treated
- Main use: Motors, transformers, FPC, FFC, and electrical gaskets
