No products were found matching your selection.
Other Related Products
-
This ASTM E1745 technical data explains how a polyethylene film vapor retarder should be reviewed below concrete slabs. It separates standard limits from typical references, lot-specific results, and project-confirmed values for thickness, water vapor permeance, tensile strength, puncture resistance, conditioned performance, and traceability. Final acceptance should use the submitted grade, current reports, and a representative mock-up under intended project conditions.
-
- Common supply form: jumbo roll, slit roll, sheet, or die-cut parts
- Appearance: clear transparent film for visible bonding areas
- Typical film base: PET clear film or heat-resistant specialty film construction
- Adhesive direction: clear acrylic bonding grade or process-matched adhesive system
- Typical use: transparent bonding, lamination, masking, and insulation
- Order style: factory production for industrial converting projects
-
An aluminum panel protective film application must keep the visible finish protected from lamination through fabrication, transport, installation and controlled removal. It is relevant to mill-finish, anodized, brushed, painted, powder-coated and coil-coated aluminum, including aluminum composite panels. The main risks are trapped particles, scratches, edge lift, film movement, difficult peeling, residue and coating appearance change. Selection should be based on the actual surface, coating condition, fabrication stress, expected exposure and removal stage—not thickness or tack alone—and should be confirmed through an actual-panel trial before full use.
-
- Material: PET substrate with ITO conductive layer
- Conductive Side: Single-side ITO coating
- Sheet Resistance: 10-15, 30-50, 80-120 ohm/sq
- Light Transmittance: Typically >=82%
- Film Thickness: 125 um or 175 um PET
- Format: ITO PET roll or ITO PET sheet
-
- Material: LDPE/PE with flame-retardant additive system
- Thickness: 50-250 um / 4-10 mil typical range
- Width: 1 m-4 m rolls, slit width available
- Colors: orange, white, natural translucent, opaque
- Roll length: 25 m, 50 m, 100 ft, or specified length
- Options: warning print, anti-static, UV grade after test confirmation
-
- Material: PE protective film
- Adhesive: acrylic pressure-sensitive adhesive
- Colors: transparent, blue, black & white
- Thickness: 25–120 microns
- Tack level: low, medium, or high
- Suitable surfaces: matte, satin, and brushed stainless steel
-
- Material: PETor PE
- Color: Clear or matte
- Adhesive: Acrylic
- Tack Level: Low to medium
- Thickness: 50-100 microns
- Supply Form: Rolls, sheets, die-cut pieces
-
Protective film for medical carpets is useful when controlled passages stay operational during personnel movement, trolley traffic, maintenance, or temporary installation work. The key is not maximum adhesion: film must remain stable at doors, turns, overlaps, and traffic hotspots while staying compatible with planned removal. Selection should balance carpet construction, surface treatment, traffic pattern, dwell time, environment, and operator method. In cleanroom or controlled areas, approve the system on the actual carpet before full-area application and retest when surface, traffic, or protection time changes.
-
Protective film for laser engraving can protect acrylic, anodized aluminum, stainless steel, and coated panels from handling scratches, smoke deposits, and workshop contamination, but the original film should not automatically remain during processing. The decision depends on the laser source, engraving mode, carrier material, adhesive chemistry, surface finish, equipment setting, and planned removal time. The main validation standard is not whether the engraving is visible; it is whether the film stays controlled during the run and can be removed after cooling without unacceptable adhesive transfer, haze, gloss change, coating lift, or fragments around fine details. Testing on the actual substrate is recommended before full use.
