No products were found matching your selection.
Other Related Products
-
- Material: hard-coated transparent PET film
- Thickness: 50-188 um, selected by coating grade
- Surface: clear gloss, low-haze hardcoat
- Hardcoat side: first visible surface
- Options: printable reverse, liner, adhesive-backed format
- Supply: slit rolls, sheets, die-cut overlay blanks
-
- Material: PET base film with EVA adhesive layer
- Finish: Clear gloss or clear matte
- Thickness: 25um-250um roll thickness
- Temperature: 90C-120C typical range
- Optical Data: >=90% light transmittance, <=3.0% haze for clear gloss grade
- Use: Thermal print lamination and printed material protection
-
- Material: PE-based monoaxially oriented film
- Appearance: Transparent, gloss, matte or application-specific finish
- Thickness: Grade-dependent; downgauged options by trial approval
- Width: Custom slit width for converting lines
- Treatment: Single-side or double-side corona treatment
- Supply Form: Finished rolls with confirmed winding direction
-
- Material: PE film
- Adhesive: Acrylic-based adhesive
- Thickness: 30–100 microns
- Width: 100–1600 mm
- Color: Transparent, blue, black & white, custom print
- Use: Composite panel processing and temporary surface protection
-
- Materials: PET, TPU, hydrogel structures
- Width: 1040 mm, 1270 mm, custom
- Length: 50 m, 100 m, custom
- Color: Clear, matte, privacy
- Thickness: 80-250 um typical
- Format: Master roll or slit roll
-
- Structure: PET carrier / acrylic PSA / release liner
- PET carrier: 25-125 um common range
- Color: clear, white, matte, or application-matched finish
- Adhesive: permanent or removable acrylic PSA
- Liner: PET, glassine, kraft, or silicone-coated liner
- Supply: jumbo roll, slit roll, narrow roll, or sheet-converted stock
-
- Material: PE film with embedded string or scrim reinforcement
- Structure: square, diamond or diagonal grid options
- Thickness: grade-dependent industrial range
- Colors: clear, white and blue options
- Supply: roll-wound or accordion-folded wide rolls
- Options: UV-stabilized, FR / NFR and reinforced-edge grades
-
Protective film for laser engraving can protect acrylic, anodized aluminum, stainless steel, and coated panels from handling scratches, smoke deposits, and workshop contamination, but the original film should not automatically remain during processing. The decision depends on the laser source, engraving mode, carrier material, adhesive chemistry, surface finish, equipment setting, and planned removal time. The main validation standard is not whether the engraving is visible; it is whether the film stays controlled during the run and can be removed after cooling without unacceptable adhesive transfer, haze, gloss change, coating lift, or fragments around fine details. Testing on the actual substrate is recommended before full use.
-
An aluminum panel protective film application must keep the visible finish protected from lamination through fabrication, transport, installation and controlled removal. It is relevant to mill-finish, anodized, brushed, painted, powder-coated and coil-coated aluminum, including aluminum composite panels. The main risks are trapped particles, scratches, edge lift, film movement, difficult peeling, residue and coating appearance change. Selection should be based on the actual surface, coating condition, fabrication stress, expected exposure and removal stage—not thickness or tack alone—and should be confirmed through an actual-panel trial before full use.
