No products were found matching your selection.
Other Related Products
-
- Material: PE protective film
- Adhesive: low tack acrylic pressure-sensitive adhesive
- Common Colors: blue, clear, translucent
- Common Thickness: 40–80 microns
- Common Roll Width: 24 mm to 1240 mm
- Typical Use: temporary protection for window glass and smooth frames
-
- Material: Clear PE protective film
- Adhesive: Low-to-medium tack acrylic
- Color: Transparent clear, custom tint optional
- Thickness: 50 um-100 um typical range
- Roll Width: 100 mm-1600 mm customizable
- Use: Outdoor-exposed window glass protection
-
- Material: removable PE protective film
- Surfaces: acrylic sheet, PMMA, plexiglass, smooth plastic sheet
- Colors: clear, blue, white, black-white, printed
- Thickness: 30-100 um by grade
- Adhesion: low, medium or adjusted tack
- Format: slit rolls with confirmed core and winding direction
-
Chemical resistance PET film data is meaningful only when construction, reagent, concentration, contact method, temperature, and exposure time are defined. It applies to PET/BOPET base film, coated PET, and adhesive-backed protective film. Compare appearance, haze, mechanical retention, coating integrity, and peel behavior after exposure. Actual-substrate testing should confirm sensitive coatings, repeated cleaning, or delayed removal.
-
- Material: Heat stabilized PET polyester film
- Appearance: Clear or milky white available
- Thickness Range: 50um-350um typical
- Roll Format: Custom slit roll width
- Surface: Untreated, one-side treated, or two-side treated
- Main Use: FPC, printed electronics, insulation, coating, baking, lamination
-
An aluminum panel protective film application must keep the visible finish protected from lamination through fabrication, transport, installation and controlled removal. It is relevant to mill-finish, anodized, brushed, painted, powder-coated and coil-coated aluminum, including aluminum composite panels. The main risks are trapped particles, scratches, edge lift, film movement, difficult peeling, residue and coating appearance change. Selection should be based on the actual surface, coating condition, fabrication stress, expected exposure and removal stage—not thickness or tack alone—and should be confirmed through an actual-panel trial before full use.
-
- Material: PE protective film
- Adhesive: acrylic pressure-sensitive adhesive
- Colors: transparent, blue, black & white
- Thickness: 25–120 microns
- Tack level: low, medium, or high
- Suitable surfaces: matte, satin, and brushed stainless steel
-
- Material: PE protective film
- Adhesive: removable water-based acrylic adhesive
- Color options: clear, blue, white
- Common thickness: 2.5-5 mil
- Common widths: 24″, 30″, 36″
- Use: temporary marble surface protection
-
This ASTM E1745 technical data explains how a polyethylene film vapor retarder should be reviewed below concrete slabs. It separates standard limits from typical references, lot-specific results, and project-confirmed values for thickness, water vapor permeance, tensile strength, puncture resistance, conditioned performance, and traceability. Final acceptance should use the submitted grade, current reports, and a representative mock-up under intended project conditions.
