No products were found matching your selection.
Other Related Products
-
Clear protective film temperature is meaningful only when film construction, adhesive system, exposure temperature, exposure time, substrate, cooling, and post-heat checks are defined. This reference applies mainly to clear PET- or PE-based temporary protective films in heated processing or controlled storage. Use tested-grade or typical values for screening, then confirm peel, dimensional change, haze, edge condition, adhesive transfer, and removal on representative samples.
-
- Material: PE-based monoaxially oriented film
- Appearance: Transparent, gloss, matte or application-specific finish
- Thickness: Grade-dependent; downgauged options by trial approval
- Width: Custom slit width for converting lines
- Treatment: Single-side or double-side corona treatment
- Supply Form: Finished rolls with confirmed winding direction
-
- Material: PE protective film
- Adhesive: acrylic pressure-sensitive adhesive
- Color: clear / transparent
- Thickness: 80–110 micron
- Roll Size: 600–1200 mm width, 50–500 m length
- Use: temporary protection for dry synthetic carpet
-
- Common thickness:20-300 um, ACP grades often 20-150 um
- Available width:300-3000 mm, slit rolls for panel lamination lines
- Resin options:EAA, EVA, PES, PO, and modified polyolefin
- Color:Transparent, translucent, milky white, or resin-dependent
- Structure:Glassine release paper or linerless roll format
- Main use:Aluminum panel bonding, aluminum honeycomb, ACP, and profile lamination
-
An aluminum panel protective film application must keep the visible finish protected from lamination through fabrication, transport, installation and controlled removal. It is relevant to mill-finish, anodized, brushed, painted, powder-coated and coil-coated aluminum, including aluminum composite panels. The main risks are trapped particles, scratches, edge lift, film movement, difficult peeling, residue and coating appearance change. Selection should be based on the actual surface, coating condition, fabrication stress, expected exposure and removal stage—not thickness or tack alone—and should be confirmed through an actual-panel trial before full use.
-
Protective film for laser engraving can protect acrylic, anodized aluminum, stainless steel, and coated panels from handling scratches, smoke deposits, and workshop contamination, but the original film should not automatically remain during processing. The decision depends on the laser source, engraving mode, carrier material, adhesive chemistry, surface finish, equipment setting, and planned removal time. The main validation standard is not whether the engraving is visible; it is whether the film stays controlled during the run and can be removed after cooling without unacceptable adhesive transfer, haze, gloss change, coating lift, or fragments around fine details. Testing on the actual substrate is recommended before full use.
-
- Material: PE film with embedded string or scrim reinforcement
- Structure: square, diamond or diagonal grid options
- Thickness: grade-dependent industrial range
- Colors: clear, white and blue options
- Supply: roll-wound or accordion-folded wide rolls
- Options: UV-stabilized, FR / NFR and reinforced-edge grades
-
- Material: Clear PE protective film
- Adhesive: Low-to-medium tack acrylic
- Color: Transparent clear, custom tint optional
- Thickness: 50 um-100 um typical range
- Roll Width: 100 mm-1600 mm customizable
- Use: Outdoor-exposed window glass protection
-
- Backing: PE, PP, PET or woven reinforced film
- Adhesive: high-tack acrylic PSA
- Thickness: 70-250 um by grade
- Color: clear, white, milky white or custom tint
- Roll: slit or wide rolls, 3 inch core
- Use: mirror backside and painted glass backing
