No products were found matching your selection.
Other Related Products
-
- Base film: flexible LDPE or application-specific HDPE
- Coating: single-side, double-side, or differential release
- Release level: easy, medium, or tight grade
- Supply format: master rolls or custom slit rolls
- Roll setup: core size and silicone side in or out confirmed
- Uses: tape, label, foam adhesive, and hygiene-material converting
-
- Material: optically clear acrylic OCA adhesive
- Structure: no-substrate adhesive with PET release liners
- Thickness: 25um-250um, grade-dependent
- Appearance: transparent, low haze, clean surface
- Format: roll, sheet, kiss-cut or die-cut part
- Use: glass, touch layer, and display module bonding
-
- Material: 3-4 mil PE/LDPE film
- Adhesive: water-based acrylic high tack
- Width: 24 inch, 36 inch, 48 inch
- Color: blue or clear
- Testing: 24-72 hour edge-lift and residue check
- Options: perforation for repeated duct openings
-
An aluminum panel protective film application must keep the visible finish protected from lamination through fabrication, transport, installation and controlled removal. It is relevant to mill-finish, anodized, brushed, painted, powder-coated and coil-coated aluminum, including aluminum composite panels. The main risks are trapped particles, scratches, edge lift, film movement, difficult peeling, residue and coating appearance change. Selection should be based on the actual surface, coating condition, fabrication stress, expected exposure and removal stage—not thickness or tack alone—and should be confirmed through an actual-panel trial before full use.
-
- Materials: PET, PE, PVC sheet
- Adhesive: acrylic PSA
- Color: clear, white, black, custom
- Form: sheets, cut pieces, die-cut parts
- Liner: paper or PET release liner
- Use: mounting, lamination, assembly
-
- Materials: PET, TPU, hydrogel structures
- Width: 1040 mm, 1270 mm, custom
- Length: 50 m, 100 m, custom
- Color: Clear, matte, privacy
- Thickness: 80-250 um typical
- Format: Master roll or slit roll
-
This ASTM E1745 technical data explains how a polyethylene film vapor retarder should be reviewed below concrete slabs. It separates standard limits from typical references, lot-specific results, and project-confirmed values for thickness, water vapor permeance, tensile strength, puncture resistance, conditioned performance, and traceability. Final acceptance should use the submitted grade, current reports, and a representative mock-up under intended project conditions.
-
- Material: APET / thermoforming PET
- Supply form: roll or sheet
- Common thickness: 150–1200 μm
- Color: clear, transparent, or custom tint
- Surface: smooth, glossy forming surface
- Main use: trays, blisters, clamshells, lids, inserts
-
- Material: PET substrate with ITO conductive layer
- Conductive Side: Single-side ITO coating
- Sheet Resistance: 10-15, 30-50, 80-120 ohm/sq
- Light Transmittance: Typically >=82%
- Film Thickness: 125 um or 175 um PET
- Format: ITO PET roll or ITO PET sheet
