No products were found matching your selection.
Other Related Products
-
Protective film for laser engraving can protect acrylic, anodized aluminum, stainless steel, and coated panels from handling scratches, smoke deposits, and workshop contamination, but the original film should not automatically remain during processing. The decision depends on the laser source, engraving mode, carrier material, adhesive chemistry, surface finish, equipment setting, and planned removal time. The main validation standard is not whether the engraving is visible; it is whether the film stays controlled during the run and can be removed after cooling without unacceptable adhesive transfer, haze, gloss change, coating lift, or fragments around fine details. Testing on the actual substrate is recommended before full use.
-
- Material: PE film
- Adhesive: acrylic pressure-sensitive adhesive
- Common colors: clear, blue, milky white
- Common thickness: 30–100 micron
- Roll format: slit rolls, log rolls, jumbo rolls
- Suitable surfaces: coated metal, stainless-look, plastic panels
-
- Material: PE protective film
- Adhesive: acrylic pressure-sensitive adhesive
- Color: clear / transparent
- Thickness: 80–110 micron
- Roll Size: 600–1200 mm width, 50–500 m length
- Use: temporary protection for dry synthetic carpet
-
- Material: Heat stabilized PET polyester film
- Appearance: Clear or milky white available
- Thickness Range: 50um-350um typical
- Roll Format: Custom slit roll width
- Surface: Untreated, one-side treated, or two-side treated
- Main Use: FPC, printed electronics, insulation, coating, baking, lamination
-
- Product Type: Clear adhesive film for graphic and photo mounting
- Manufacturer: Films Protective Company
- Appearance: Transparent adhesive layer with clear release liner
- Common Widths: 635 mm, 1040 mm, 1300 mm, 1520 mm, custom width available
- Application Method: Cold lamination, roller pressure, face mounting
- Main Uses: Acrylic photo panels, display boards, printed graphics, rigid presentation panels
-
An aluminum panel protective film application must keep the visible finish protected from lamination through fabrication, transport, installation and controlled removal. It is relevant to mill-finish, anodized, brushed, painted, powder-coated and coil-coated aluminum, including aluminum composite panels. The main risks are trapped particles, scratches, edge lift, film movement, difficult peeling, residue and coating appearance change. Selection should be based on the actual surface, coating condition, fabrication stress, expected exposure and removal stage—not thickness or tack alone—and should be confirmed through an actual-panel trial before full use.
-
- Standard wafer sizes:4 inch, 6 inch, 8 inch, 12 inch
- Film color:Blue transparent or clear
- Backing material:PO, PVC, or PET-based film
- Adhesive type:UV-sensitive acrylic adhesive
- Process use:Wafer mounting, blade dicing, irradiation, die pick-up
- Clean packaging:Individual roll pack, double anti-static PE bag, lot traceable
-
- Material: heat-stabilized PET polyester film
- Thickness: 50 um, 75 um, 100 um, 125 um, 175 um
- Surface: corona treated, primer coated, or chemically treated
- Color: clear, slightly hazy, or white
- Ink fit: silver ink, carbon ink, dielectric ink
- Uses: flexible circuits, printed sensors, RFID antennas, membrane switches
-
- Material: Clear PE protective film
- Adhesive: Low-to-medium tack acrylic
- Color: Transparent clear, custom tint optional
- Thickness: 50 um-100 um typical range
- Roll Width: 100 mm-1600 mm customizable
- Use: Outdoor-exposed window glass protection
